Aiwa PB batteries compatibility

Discussion in 'Tech talk' started by Raul, Aug 20, 2023.

  1. Raul

    Raul Active Member

    Messages:
    228
    Trophy Points:
    43
    Location:
    Szczecin
    Does anyone know what Aiwa PB batteries fits/are compatibile with which Aiwa models?
    For now I would like to know about PX101 and PX303, but I think there could be a sticky thread because there are now litiumIon replacement batteries on Aliexpress.
    Thanks
     
  2. Radio Raheem

    Radio Raheem Well-Known Member

    Messages:
    1,961
    Trophy Points:
    113
    Location:
    uk
    wish i could help the px101 didn't even know it ran on rechargeable batts and i have had loads of them, dementia comes to mind lol the 303 is that the one with dolby c pic please....if so
    i have one but it fell behind my chest of draws which i have all my amps on so it can stay there

    but wouldn't a panasonic one fit, I'm not sure of that though
     
    Last edited: Aug 20, 2023
  3. Radio Raheem

    Radio Raheem Well-Known Member

    Messages:
    1,961
    Trophy Points:
    113
    Location:
    uk
    damn the 303 is the one i have Raul..... it would take me hours just to move my amps and set them back up again but i am tempted but it may kill me lol
     
    Raul likes this.
  4. Raul

    Raul Active Member

    Messages:
    228
    Trophy Points:
    43
    Location:
    Szczecin
    If it's hard to get I would avoid it :)
     
  5. Radio Raheem

    Radio Raheem Well-Known Member

    Messages:
    1,961
    Trophy Points:
    113
    Location:
    uk
    done i need a couple of walkman screws as one is missing off the door hinge. walkman still works and sounds superb lad:wink2:wave:it's you're fault god bless atb Reno:wink2
     
    Last edited: Aug 21, 2023
    Raul likes this.
  6. Raul

    Raul Active Member

    Messages:
    228
    Trophy Points:
    43
    Location:
    Szczecin
    For now if I think correctly PX101 use PB1 and PB3, PX303 probably PB4?
     
  7. Emiel

    Emiel Well-Known Member S2G Supporter

    Messages:
    1,050
    Trophy Points:
    113
    Location:
    Western Europe
    Please check the Dolby C overview in my signature too. I included the batteries of the units and am happy to make changes when required.
     
    Last edited: Aug 24, 2023
    Valentin and Raul like this.
  8. Raul

    Raul Active Member

    Messages:
    228
    Trophy Points:
    43
    Location:
    Szczecin
    Thanks, I didn't know you added the battery in chart :)

    Strange, PX20 which is supposedly same package but different head and electronics to PX10 is listed as using PB-2.
    I'm not sure, but aren't PB1, 2 and 3 compatibile?
     
    Last edited: Aug 23, 2023

Share This Page