Alright, it's finally done! To install the regulator, I had to separate the supply from b+. I did this by cutting the trace leading from the dc...
Cool. I've ordered the parts, should be here in a week or two.
Alright, I believe I have found quite the tasty regulator: 2A capability with a Vdropout of around 50mV at around 300mA (I think)...
I reckon adding a voltage regulator is worth a shot. So I measured FF/RW current when stopped and got ~275mA. As for the lowest voltage the...
Not sure where to buy a spring, but if you get a small piece of metal it is possible to bend it around to make a spring. Did this once on a ddII....
Right thanks for the clarification on tone frequency, I'll record the correct frequency tape once my deck has been repaired(it's direct drive dont...
Alright. So far I have lubricated the mechanism, changed the belt, replaced all electrolytic caps and adjusted the motor speed. Now it works...
I've replaced the belt and cleaned all of the gears and such, but I haven't been able to figure out why. The grinding seems to be due to the...
I have recently purchased a wm-2 on eBay. After repairing the disk, replacing the motor (The Original one was seized) and belt, I was astonished...
Hi, everyone!
Separate names with a comma.
