I cleaned up a few parts and got W&F around 0.13% without PLL and then around 0.08% connected, with everything working properly. I put it back...
This is for PLL disconnected ... W&F around 0.3-0.4
thanks Valentin. I did not clean the rubber ring but did thoroughly clean the head, capstan and pinch with a special formula S-721H beforehand....
Hey all, I just finished going through a WM-DD3 according to the step-by-step instructions. Replaced the center gear, small gear, rubber idler...
Sounds good, thanks for the tips. The original center gear looks to be fully in tact, would you still replace it ? This is the lube I have, is it...
For those that are into vinyl, one thing that I am really into is DIY phono preamps. I've built quite a few by now, although ironically I am...
Well, I played around with it and found out that the motor was rotating in the wrong direction, so the center gear was not lifting the latch. I...
Hi and thanks both! I mainly collect vinyl, but have a few hundred CDs (from past collection) and have recently started with a modest cassette...
Hi all, I'm working on a WM-2. I've ordered all the parts from Mihok (belts, pinch rollers, center gear and small gear) so have them on hand if...
Hi all, I've got an WM-AF22 that is in really good cosmetic condition, overall very clean. I opened it up and replaced the belts (which I bought...
Hi all, New to this forum but have been fairly active in other DIY audio sites such as DIYAudio, AudioKarma and more recently tapeheads. I've...
Separate names with a comma.
