Thanks. "Belt, pulley" - X "Belt (A)" - https://fixyouraudio.com/product/square-rubber-belt-28x1-2-for-cassette-players-and-cd-players-falymc/...
Does anyone have the dimensions of the belts, idlers and pinch roller? I can't buy on eBay, but maybe I can find something by dimensions from...
Can you update link, above don't work)
Thanks for detailed answer, I mainly use Type I. I'll leave the settings for Type I then.
Now I understand, thanks. One more question) When I set levels for type I and check it on type II, levels a higher about 20 mV. Should I lower the...
@Valentin hello, need your advice) I try to adjust record level. First I check playback level with manual, it 250 mV in both channels at 315 Hz...
@Valentin thanks. I change connection in line out with only 1 resistor in one channel at a time, and now it seems work right. For dolby I get both...
@Valentin Hi, 47K one for left and one for right channel? Like in my photo? Dolby switcher must be turned off? Without any adjustments I get 140mV...
I bypassed CP101 and left channel works fine :) Than I decided bypass and CP201 too. As I understand MPX filter for records from FM radio and it...
I checked CP101 and @Deb64 I think you were right. I run 1kHz from my phone to line in and what I get: On line in contact R L...
I will try tomorow check CP101 and CP201 output pin. As I understand I need measure voltage between ground and 6 pin on CP 101 and CP201? Their...
@Deb64 thank you, can I use multimeter with true RMS instead oscilloscope? I don't have oscilloscope unfortunately :(
Hi @Deb64 I recently replaced the EQ modules too and there was an printed photo in the parcel how to solder it, and CP303 in a different position...
@Valentin thank you for great tutorial. Can I use this test tape for Dolby levels? It's 400Hz instead 330Hz in your instruction. Or it doesn't...
Can you share some photo or diagram where to solder diode and regulator?
Separate names with a comma.