Rotation is transferred to the table reels through the big idler by touching the FG magnet part of the flywheel. But for that to happen, the...
For this application, you use the substance as-is, no need to dillute with water. Soak a cottom swab in it, put unit in FF or REW and keep the...
C102/202 are SMD tantalums on this models, these are on the other side of the PCB near head preamp IC. See picture attached. If you bought the kit...
Regarding the FF/REW, does the motor move at all when FF/REW buttons are pressed ? Is the motor position correctly adjusted (perpendicular to...
Muffled sound is not related to the caps. Failing caps would affect the other end of the spectrum (sub-bass), but even then they would have to be...
Looks like it. However these tantalum capacitors have higher ESR than electrolytics, that alone doesn't tell much. The unfortunate part is the...
The ATT switch is only related to MIC input. The thumping sound happends during record, playback or both ? Not working after re-assembly...
What's interesting is the motor works when powered separately. I would test the motor on a power supply and vary the voltage, maybe there's a dead...
These thin motors do look intimidating to open, but now that I see it opened realise the risk isn't that high. This is a coreless motor, similar...
In the video it's presented a motor that has the servo circuit built-in and it's that built-in servo making the motor run fast. A motor could...
Can you do a recording of the thumping sound ?
Have you tested the motor outside of circuit ? Would want to make sure the motor itself doesn't have a problem before suspecting anything in the...
Generally speaking in such cases, there are 3 things that can go wrong: - the lever may be hard to turn due to hardened grease (not aware being a...
From calibrations done before on D6/D6Cs the difference between measuring directly (multimeter 10MΩ input) and with 47kΩ load is about 20-30mV...
Something isn't clear here: you stated this current spike only happens for 2 seconds at startup and then current draw goes back to normal (normal...
Yes that's it. Do keep in mind the amp may or may not be the problem. Without more measurements it's hard to tell. If you have a scope, checking...
As long as the voltages at the Dolby chip don't change, you're fine as far as the Dolby decoding goes. Read the Dolby IC datasheet myself, will...
Hello and welcome to the forum, @sebywalkman ! Regarding your Cybernet PS-101, that's very similar to the Infinity Intimate I posted here:...
In order to know for sure if it's indeed the brass pulley that lowers the W&F, you must test the same unit with both brass and plastic. Otherwise...
My preffered way to remove caps is using soldering iron, but the corrosion needs to be cleaned a bit first otherwise it will be a bit hard to melt...
Separate names with a comma.
